Helix M One Monoblock Subwoofer Amplifier Made In Germany

  

HELIX M ONE Car Audio Mono Sub Subwoofer Amplifier 600w RMS at 1 ohm. It has some signs of use in front side of it which was covered with black marker.

Other than that, it is in perfect condition. Never used above its rms power. It comes with original box, volume knob and volume knob's cable. Small, efficient and unconditionally stable - the M ONE is a highly compact monoblock for subwoofer applications.

Built in state-of-the-art Class D technology, this amp even controls speakers with only 1 ohm impedance under control. This is accompanied by a comprehensive and extremely practical equipment that leaves nothing to be desired. And finally, thanks to the small dimensions of this mini power plant, there is always a slot. Very compact Class D amplifier with high output power from 600 watts RMS to 1 ohm - ideally suited for combination with all 2 x 2 ohm subwoofers in parallel operation. Starting plugability down to 6V supply voltage.

Intelligent high level input with ADEP (Advanced Diagnostics Error Protection) circuitry and auto power on. Integrated, active crossover with low pass, bass boost, subsonic and phase.

Extremely stable power amp with high current power transistors and 1 ohm stability. Wired remote control for volume control. SMD (Surface Mounted Device) technology combines minimal space requirements with maximum reliability. Exclusive, very compact design with illuminated HELIX logo and low heat generation thanks to very high efficiency.

Modern, factory-installed car radios are becoming increasingly intelligent in terms of diagnosing the connected speakers. If an amplifier is instead connected to the radio, there is usually error messages up to the loss of individual functions (such as fader). The new ADEP circuit (Advanced Diagnostics Error Protection) prevents all these problems without the speaker outputs of the radio at high levels unnecessary strain.

The power supply in the HELIX M ONE amplifier ensures the internal power supply even with short-term drops down to 6 volts. This ensures that the HELIX M ONE remains fully functional even when the engine is started. 1 x 600 / 1,200 watts.

2 x high level speaker input. 1 x remote control input. RCA 0.5 - 6 volts. High 1.1 - 13 volts. Signal converter for the digital input.

10 Hz - 250 Hz. 0-12 dB / 25-75 Hz. 50 Hz - 250 Hz adjustable. 10 Hz - 250 Hz adjustable.

10 Hz - 50 Hz adjustable. 0 - 180 ° adjustable. Slope high / low pass. Slope Subsonic / Low Pass. 10.5 - 16 volts (maximum 5 seconds down to 6 volts).

2 x 35 A maxi plug fuse (FK3). Active, adjustable crossover, bass boost.

Phase shift, start-up capability, auto-engaged high level input and Advanced Diagnostics Error Protection (ADEP), bass level remote control. Dimensions (H x W x D).

50 x 230 x 154 mm.