Channel High Power

EverSolo AMP-F2 Stereo Power Amplifier Black

EverSolo AMP-F2 Stereo Power Amplifier Black
EverSolo AMP-F2 Stereo Power Amplifier Black
EverSolo AMP-F2 Stereo Power Amplifier Black
EverSolo AMP-F2 Stereo Power Amplifier Black
EverSolo AMP-F2 Stereo Power Amplifier Black

EverSolo AMP-F2 Stereo Power Amplifier Black   EverSolo AMP-F2 Stereo Power Amplifier Black

EverSolo AMP-F2 Stereo Power Amplifier Black. Innovative Balanced Power Amp With Bridged Mono Mode. This compact chassis contains a formidable power amplifier.

The muscular AMP-F2 was developed in collaboration between the Starke Sound team and the Eversolo team. It is based on the innovative NS600 amplifier module created by Starke Sound. The AMP-F2 boasts a high sampling rate of up to 600KHz.

Simultaneously, it significantly reduces noise and enhances dynamic performance through the newly designed SAPS audio-specific switch power supply. This highly agile amp employs an efficient Class D amplification structure, coupled with optimized circuits to maximize audio quality. The AMP-F2 is bridgeable, allowing flexible configuration for two-channel or mono-channel setups when needed. When bridged, it can support up to 450W RMS (202) with THD+N still below 1%. This ability to handle extremely low-impedance loads ensures ample energy even in large and challenging speaker setups, particularly in cases incurring high-dynamic low-frequency outputs. The NS600 module employs PurePath Ultra-HD technology and advanced integrated feedback design, featuring high-speed gate driver error correction functions. This technology achieves ultra-low distortion across the entire audio frequency range, delivering exceptional high-end audio quality.

The balanced design of the AMP-F2 provides a pair of XLR balanced inputs as well as a pair of single-ended RCA inputs. The premium output terminals consist of two pairs of beryllium copper binding posts custom-made by Starke Sound. The AMP-F2 is equipped with standard 12-volt Trigger In and Trigger Out functions, allowing it to be synchronized with other devices that support the standard Trigger interface for power on and off. For'greener' operation, the AMP-F2 has an extremely low standby power (0.5W) and idle power consumption (14W), complying with the European Union ErP standards.

The specially designed shielded aluminum chassis uses an anti-interference design to avoid disturbances from various electrical environments. Balanced design two-channel power amplifier. Newly designed SAPS audio-specific switch power supply. Efficient Class D amplification structure, coupled with optimized circuits to maximize audio quality. Starke Sound NS600 amplifier module. Input terminals: 2-Channel RCA, 2-Channel XLR. Output terminals: 2 pairs beryllium copper binding posts custom made by Starke Sound. Control option: 12V trigger input and output. 145W RMS at 8 ohms (1% THD). 250W RMS at 4 ohms (1% THD). 280W RMS at 4 ohms (1% THD, BTL) 450W RMS at 2 ohms (1% THD, BTL). Maximum output current per channel: 16.5A/33A(Bridge).

Signal-To-Noise Ratio (SNR): >110dB, "A" weighted at 4 ohm 250W. THD: 0.003% 10W at 1KHz.

(5 Hz to 100 kHz). Minimum load impedance: 0.8? Heat: 65 BTU / hr. Dimensions: 10.6" × 9.0" × 3.1 high.


EverSolo AMP-F2 Stereo Power Amplifier Black   EverSolo AMP-F2 Stereo Power Amplifier Black